Security Control System without intelligent key system
Security indicator lamp does not turn on or blink
In this manual: Security Control System without intelligent key system
~1min read
Description
Security indicator lamp does not blink when ignition switch is in a position other than ON.
NOTE:• Before performing the diagnosis, check “Work Flow”. Refer to SEC-187, "Work Flow".
• Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” before starting diagnosis, and check each symptom.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
Power supply position is not the ON position.
Diagnosis Procedure
1.CHECK SECURITY INDICATOR LAMPCheck security indicator lamp function.
Refer to SEC-159, "Component Function Check".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATIONConfirm the operation again.
Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> GO TO 1.
Was this page helpful?