Body Exterior, Doors, Roof & Vehicle Security
Additional Service When Replacing Control Unit. Ecm
In this manual: Body Exterior, Doors, Roof & Vehicle Security
5steps
~30min
2/5difficulty
Done 0 of 5
Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*.
*: New one means an ECM that has never been energized on-board.
(In this step, initialization procedure by CONSULT is not necessary)
PERFORM ECM RECOMMUNICATING FUNCTION
Install ECM.
Contact back side of registered Intelligent Key* to push-button ignition switch, then place ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
Maintain ignition switch in the ON position for at least 5 seconds.
Ignition switch OFF.
Check that the engine starts.
GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform Work Procedure.
>>Work End.
Was this page helpful?