Body Exterior, Doors, Roof & Vehicle Security

Roof :: Unit Disassembly and Assembly. Sunshade

~2min read
Disassembly and Assembly
  • Do not over tighten screws on the moonroof unit bases or damage may occur.

DISASSEMBLY

Open the sunshade leaving eight inches showing.

Remove panoramic roof glass. Refer to Removal and Installation.

Release sunshade retainer (2) from sunshade retainer couplings (1) (LH/RH).

Release the sunshade retainer from both couplings (LH/RH) by pulling rearward as shown. Rotate the sunshade retainer 90 degrees as shown.
Pull back the sunshade retainer (2) to remove ends from each sunshade coupling (1) (LH/RH).

Remove sunshade (1) by applying pressure toward the drivers side and pulling rearward from the moonroof bases.

Remove moonroof unit base screws (A).

Disassemble by pulling off both moonroof unit bases (LH/RH) from the moonroof unit tracks.

Manually disengage the sunshade motor and moonroof motor assembly using a suitable tool then remove both sunshade cables and glass lid cables by pulling rearward.

Remove the cable guides (LH/RH) by pulling rearward from the moonroof unit tracks.

ASSEMBLY

Insert the sunshade and glass lid cables guides by sliding forward on the moonroof unit track.

Assembly moonroof unit bases (2) (LH/RH) by pushing forward on the moonroof unit tracks (1) (LH/RH).

Insert sunshade black hem over lower guide (3) and under upper guide (2) on the moonroof unit bases (1) (LH/RH).

(1) Sunshade black hem.

(2) Sunshade fabric.

Assemble the sunshade by applying pressure towards the drivers and inserting both ends into the moonroof unit bases (LH/RH).

Assemble sunshade retainer.

Position the sunshade retainer on the backside of the moonroof unit couplings then position the moonroof unit couplings inside the sunshade stays open channel. Rotate the sunshade 90 degrees. Snap in place both ends of the sunshade stay on both LH/RH sunshade couplings.

Manually engage the sunshade motor and moonroof motor assembly using a suitable tool

With the sunshade (2) assembled remove the sunshade spring retainer pin (1).

Install panoramic roof glass. Refer to Removal and Installation.

Install moonroof unit assembly. Refer to Removal and Installation.