Body Exterior, Doors, Roof & Vehicle Security

Back Door Assembly

~3min read
Exploded View
1. Back door 2. Back door weather stripping 3. Back door hinge (LH/RH)
4. Back door upper stud ball or spindle unit upper hinge (with power back door) (LH) 5. Back door lower stud ball or spindle unit lower hinge (with power back door) (LH) 6. Back door striker
7. Back door lower stud ball or spindle unit upper hinge (with power back door) (RH) 8. Back door upper stud ball or spindle unit lower hinge (with power back door) (RH)
Removal and Installation

REMOVAL

Support back door assembly using a suitable tool.

Disconnect spindle units (LH/RH) or back door upper stud balls (LH/RH) from back door assembly. Refer to Removal and Installation (WITH AUTOMATIC BACK DOOR) or Removal and Installation (WITHOUT AUTOMATIC BACK DOOR).

Disconnect the harness connectors from the back door.

Remove back door harness grommet then pull harness from back door.

Disconnect washer tube.

Remove washer tube grommet and washer tube from back door.

Remove back door hinge bolts (door side) and back door assembly.

INSTALLATION

Installation is in the reverse order of removal.

Adjustment

1. Rear spoiler 2. Roof 3. Quarter window finisher
4. Side air spoiler 5. Rear combination lamp 6. Rear bumper
7. Back door 8. Back-up lamp

Check clearance and surface height between back door and each part by visual inspection and tactile feel. If clearance and surface height are out of specification, adjust them according to adjustment procedure.

Unit: mm (in)

PortionSectionItemMeasurementStandardParallelism
Spoiler – Roof A – A E Clearance 6.0 ± 1.0 (0.24 ± 0.04) 1.5 (0.06)
F Surface height 0.3 ± 1.0 (0.01 ± 0.04) 1.5 (0.06)
Quarter window finisher – Side air spoiler B – B G Clearance 3.0 ± 2.4 (0.12 ± 0.09) 1.9 (0.07)
H Surface height — —
Rear combination lamp – Back-up lamp C – C J Clearance 5.0 ± 2.0 (0.18 ± 0.08) 2.0 (0.08)
K Surface height — —
Rear bumper – Back door D – D L Clearance 6.0 ± 1.9 (0.19 ± 0.08) 2.0 (0.08)
M Surface height 0.5 ± 1.9 (0.02 ± 0.07) —

Loosen back door hinge nuts (door side).

Lift up back door approximately 100 – 150 mm (3.94 – 5.91 in) height then close it lightly and check that it is engaged firmly with back door closed.

Check clearance and surface height according to specifications provided.

Tighten back door hinge nuts to specified torque.