Brake Fluid
DRAINING
Turn ignition switch OFF and disconnect the harness connector from the ABS actuator and electric unit (control unit) or negative battery terminal. Refer to Removal and Installation.
Connect a vinyl tube to bleeder valve.

Depress brake pedal, loosen bleeder valve, and gradually remove brake fluid.
REFILLING
Make sure no foreign material is in the reservoir tank or sub tank, and refill with new brake fluid.

Refill the brake system as follows:
Depress the brake pedal.
Loosen bleeder valve.
Slowly depress brake pedal to 2/3 of the brake pedal full stroke.
Tighten bleeder valve.
Release brake pedal.
Repeat this operation at intervals of two or three seconds until all old brake fluid is discharged. Add new brake fluid to sub tank frequently.
Bleed the air out of the brake hydraulic system. Refer to Bleeding Brake System.
Turn ignition switch OFF and disconnect the harness connector from the ABS actuator and electric unit (control unit) or negative battery terminal. Refer to Removal and Installation.
Connect a vinyl tube to front (RH) brake caliper bleeder valve.
Fully depress brake pedal 4 or 5 times.
With brake pedal depressed, loosen bleeder valve to bleed air in brake line, and then tighten it immediately.
Repeat steps 3 and 4 until all of the air is out of the brake line.
Tighten the bleeder valve to the specified torque. Refer to Exploded View (front disc brake), Exploded View (rear disc brake).
Repeat steps 2 through 6, with sub tank filled at least halfway. Bleed the air in the following order from the front (RH), front (LH), rear (RH), rear (LH).