Body Exterior, Doors, Roof & Vehicle Security

Check Anti-Pinch Function

~1min read
Description

The initialization is necessary for normal operation of power window system If any of the following operations are performed:

  • When control unit is replaced.

  • Electric power supply to power window switch or motor is interrupted by blown fuse or disconnection and connection of the negative battery terminal.

  • Removal and installation of regulator assembly.

  • Power supply to the main power window and door lock/unlock switch or power window motor is cut off by the removal of battery terminal or if the battery fuse is blown.

  • Disconnection and connection of main power window and door lock/unlock switch harness connector.

  • Removal and installation of motor from regulator assembly.

  • Operation of regulator assembly as an independent unit.

  • Removal and installation of door glass.

  • Removal and installation of door glass run.

The following specified operations can not be performed under the non-initialized condition:

  • Auto-up operation

  • Anti-pinch function

Work Procedure

CHECK ANTI-PINCH FUNCTION

  • Fully open the door window.

  • Place a piece of wood near fully closed position.

  • Close door glass completely with AUTO-UP.

  • Check the following conditions:

    • Check that glass lowers for approximately 150 mm (5.9 in) without pinching piece of wood and stops.

    • Check that glass does not rise when operating the main power window and door lock/unlock switch while lowering.

>>

Inspection End.