Instruments and controls
Clearing the programmed information
In this manual: Instruments and controls
2steps
~12min
1/5difficulty
Done 0 of 2
The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed. For additional information, refer to “Reprogramming a single HomeLink® button” in this section.
To clear all programming:
- Press and hold the two outer HomeLink® buttons until the indicator light begins to flash in approximately 10 seconds. Do not hold for longer than 20 seconds.
- Release both buttons.
HomeLink® is now in the programming mode and can be programmed at any time beginning with “Programming HomeLink®” - Step 1.
Was this page helpful?