Instruments and controls
Reprogramming a single HomeLink® button
In this manual: Instruments and controls
2steps
~12min
1/5difficulty
Done 0 of 2
To reprogram a HomeLink® Universal Transceiver button, complete the following:
- Press and hold the desired HomeLink® button. DO NOT release the button.
- The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed with “Programming HomeLink®” - Step 1.
For questions or comments, contact HomeLink® at: www.homelink.com or 1–800–355–3515 (except Mexico).
The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pressing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.
Was this page helpful?