Electrical & Power Control

Combination Switch Reading System

~3min read
System Description

SYSTEM DIAGRAM

OUTLINE

  • BCM reads the status of the combination switch (light, turn signal, wiper and washer) and recognizes the status of each switch.

  • BCM has a combination of 5 output terminals (OUTPUT 1 - 5) and 5 input terminals (INPUT 1 - 5) and reads a maximum of 19 switch states.

COMBINATION SWITCH MATRIX

Combination switch INPUT-OUTPUT system list
SystemINPUT 1INPUT 2INPUT 3INPUT 4INPUT 5
OUTPUT 1 — FR WASHER FR WIPER LOW TURN LH TURN RH
OUTPUT 2 FR WIPER HI — FR WIPER INT/AUTO PASSING HEADLAMP 1
OUTPUT 3 INT VOLUME 1 RR WASHER — HEADLAMP 2 HI BEAM
OUTPUT 4 RR WIPER INT INT VOLUME 3 AUTO LIGHT — TAIL LAMP
OUTPUT 5 INT VOLUME 2 RR WIPER ON — FR FOG —

COMBINATION SWITCH READING FUNCTION

Description

  • BCM reads the status of the combination switch at 10 ms intervals normally.

  • BCM operates as follows and judges the status of the combination switch.

    • It operates the transistor on OUTPUT side in the following order: OUTPUT 1 → 2 → 3 → 4 → 5, and outputs voltage waveform.

    • The voltage waveform of OUTPUT corresponding to the formed circuit is input into the interface on INPUT side if any (1 or more) switches are ON.

    • It reads this change of the voltage as the status signal of the combination switch.

Operation Example

In the following operation example, the combination of the status signals of the combination switch is replaced as follows: INPUT 1 - 5 to “1 - 5” and OUTPUT 1 - 5 to “A - E”.

Example 1: When a switch (TAIL LAMP) is turned ON

  • The circuit between OUTPUT 4 and INPUT 5 is formed when the TAIL LAMP switch is turned ON.

  • BCM detects the combination switch status signal “5D” when the signal of OUTPUT 4 is input to INPUT 5.

  • BCM judges that the TAIL LAMP switch is ON when the signal “5D” is detected.

Example 2: When some switches (TURN RH, TAIL LAMP) are turned ON

  • The circuits between OUTPUT 1 and INPUT 5 and between OUTPUT 4 and INPUT 5 are formed when the TURN RH switch and TAIL LAMP switch are turned ON.

  • BCM detects the combination switch status signal “5AD” when the signals of OUTPUT 1 and OUTPUT 4 are input to INPUT 5.

  • BCM judges that the TURN RH switch and TAIL LAMP switch are ON when the signal “5AD” is detected.

WIPER INTERMITTENT DIAL POSITION SETTING (FRONT WIPER INTERMITTENT OPERATION)

BCM judges the wiper intermittent dial 1 - 7 by the status of INT VOLUME 1, 2, and 3 switches.

Wiper intermittent

dial position
Switch status
INT VOLUME 1INT VOLUME 2INT VOLUME 3
1 ON ON ON
2 ON ON OFF
3 ON OFF OFF
4 OFF OFF OFF
5 OFF OFF ON
6 OFF ON ON
7 OFF ON OFF