Ventilation, Heater & Air Conditioner

Compressor Does Not Operate

7steps
~42min
2/5difficulty
Done 0 of 7
Diagnosis Procedure

Symptom: A/C compressor does not operate.

CHECK MAGNET CLUTCH OPERATION

Check magnet clutch. Refer to Component Function Check.

Does it operate normally?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning parts.

CHECK REFRIGERANT PRESSURE SENSOR

Check refrigerant pressure sensor. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace malfunctioning parts.

CHECK A/C AUTO AMP. OUTPUT SIGNAL

CONSULT

  1. Select “COMP REQ SIG” and “FAN REQ SIG” in “Data Monitor” mode of “HVAC”.

  2. Check that the function operates normally according to the following conditions:

    Monitor itemConditionStatus
    COMP REQ SIG A/C switch ON On
    OFF Off
    FAN REQ SIG Front blower motor ON On
    OFF Off

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Replace A/C auto amp. Refer to Removal and Installation.

CHECK ECM INPUT SIGNAL

CONSULT

  1. Select “AIR COND SIG” and “HEATER FAN SW” in “Data Monitor” mode of “ENGINE”.

  2. Check that the function operates normally according to the following conditions:

    Monitor itemConditionStatus
    AIR COND SIG A/C switch ON On
    OFF Off
    HEATER FAN SW Front blower motor ON On
    OFF Off

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

CHECK IPDM E/R INPUT SIGNAL

CONSULT

  1. Start engine.

  2. Select “AC COMP REQ” in “Data Monitor” mode of “IPDM E/R”.

  3. Check that the function operates normally according to the following conditions:

    Monitor itemConditionStatus
    AC COMP REQ A/C switch ON On
    OFF Off

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.