Driver Information & Multimedia

Configuration (av Control Unit)

2steps
~12min
2/5difficulty
Done 0 of 2
Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing AV control unit.

Configuration has three functions as follows:

FunctionDescription
"Before Replace ECU"
  • Reads the Nissan Murano vehicle configuration of current AV control unit.

  • Saves the read vehicle configuration.

"After Replace ECU" Writes the Nissan Murano vehicle configuration with manual selection.
"Select Saved Data List" Writes the Nissan Murano vehicle configuration with saved data.
Work Procedure

WRITING MODE SELECTION

CONSULT Configuration

Select “Re/programming, Configuration” of "MULTI AV".

When writing saved data>>

GO TO 2.

When writing manually>>

GO TO 3.

WRITING Nissan Murano Vehicle SPECIFICATION

CONSULT Configuration

Select “Configuration” or “After Replace ECU”, and write the Nissan Murano vehicle specification saved in CONSULT to AV control unit.

>>

GO TO 4.

WRITE Nissan Murano Vehicle SPECIFICATION

CONSULT Configuration

  1. Select “Re/programming, Configuration” of "MULTI AV".

  2. Select “Manual Configuration”, and write the setting value as shown in the following table to AV control unit according to the Nissan Murano vehicle specification.

    MANUAL SETTING ITEMDetail
    ItemsSetting value
    NAVIGATION WITH Models with navigation system
    WITHOUT Models without navigation system
    SOUND SYSTEM BOSE Models with Bose audio
    NORMAL 6SPKS Models without Bose audio
    CAMERA SYSTEM NONE or AVM ph3 Models with Intelligent around view monitor system
    REAR Models with rear view monitor system
    SONAR TYPE None Models without sonar
    REAR Models with sonar
    PREDICTIVE COURSE LINE Without or with (with AVM) Models with Intelligent around view monitor or without camera
    With (Rear view camera) Models with rear view monitor
>>

GO TO 4.

PERFORM SELF-DIAGNOSIS

CONSULT Self Diagnostic Result

Perform self-diagnosis of CONSULT, and check whether or not DTC B1341–55 is detected.

Is DTC B1341–55 detected?

YES>>

GO TO 1.

NO>>

GO TO 5.

OPERATION CHECK

Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.

YES>>

Work End.