Door Assembly

| 1. | Rear door sash | 2. | Rear door outside rear tape | 3. | Rear door sash rear tape |
| 4. | Rear door striker | 5. | Rear door weather strip | 6. | Rear door seal |
| 7. | Vapor barrier | 8. | Rear door lower hinge | 9. | Rear door check link |
| 10. | Rear door upper hinge | 11. | Rear door sash front tape | 12. | Rear door outside front tape |
| Clip |
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Remove rear door vapor barrier.
Disconnect the harness connectors from the rear door.
Remove harness grommet from rear door then pull out rear door harness from rear door.
Remove rear door check link bolt (body side).
Remove rear door hinge nuts (door side) and rear door assembly.
INSTALLATION
Installation is in the reverse order of removal.

| 1. | Front fender | 2. | Front door | 3. | Rear door |
| 4. | Body side outer | 5. | Rear door upper hinge | 6. | Rear door lower hinge |
| 7. | Door striker | F. | Door striker bolts |
Check clearance and surface height between rear door and each part by visual inspection and tactile feel.
If clearance and surface height are out of specification, adjust them according to adjustment procedures.
Unit: mm (in)
| Portion | Section | Measurement | Standard |
|---|---|---|---|
| Front fender - Front door | A – A | Clearance | 3.5 ± 1.0 (0.14 ± 0.04) |
| Surface height | ± 1.0 (± 0.04) | ||
| Front door - Rear door | B – B | Clearance | 4.0 ± 1.0 (0.16 ± 0.04) |
| Surface height | ± 1.0 (± 0.04) | ||
| Rear door - Body side outer | C – C | Clearance | 3.2 ± 1.0 (0.13 ± 0.04) |
| Surface height | ± 1.0 (± 0.04) |
Remove center pillar lower finisher. Refer to Removal and Installation.
Loosen rear door hinge nuts (door side).
Adjust surface height of rear door according to specifications provided.
Temporarily tighten rear door hinge nuts (door side).
Loosen rear door hinge nuts and bolts (body side).
Raise rear door at rear end to adjust clearance of rear door according to specifications provided.
After adjustment, tighten bolts and nuts to specified torque.
Install center pillar lower finisher. Refer to Removal and Installation.