Electrical & Power Control
Ecu Diagnosis Information. 3ch Can Gateway
In this manual: Electrical & Power Control
2steps
~12min
1/5difficulty
Done 0 of 2
TERMINAL LAYOUT

PHYSICAL VALUES
Terminal No. (Wire color) | Description | Condition | Standard | Reference value | |||
|---|---|---|---|---|---|---|---|
| + | – | Signal name | Input/ Output | ||||
1 (L) |
— | Nissan Murano Vehicle CAN communication-H | Input/ Output | — | — | — | |
2 (P) |
— | Nissan Murano Vehicle CAN communication-L | Input/ Output | — | — | — | |
3 (L) |
— | Diagnostic CAN communication-H | Input/ Output | — | — | — | |
4 (P) |
— | Diagnostic CAN communication-L | Input/ Output | — | — | — | |
5 (BG) |
6 (B) 7 (B) |
Ignition power supply | Input | Ignition switch ON | 7 – 16 V | Battery voltage | |
8 (BG) |
6 (B) 7 (B) |
Battery power supply | Input | Ignition switch OFF | 6 – 16 V | Battery voltage | |
9 (L) |
— | IT CAN communication-H | — | — | — | — | |
10 (P) |
— | IT CAN communication-L | — | — | — | — | |
11 (L) |
— | Diagnostic CAN communication-H | Input/ Output | — | — | — | |
12 (P) |
— | Diagnostic CAN communication-L | Input/ Output | — | — | — | |
13 (L) |
— | IT CAN communication-H | — | — | — | — | |
14 (P) |
— | IT CAN communication-L | — | — | — | — | |
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.
B2600-46: CONFIG ERROR [CALIB/PRMTER MEMORY ERROR]
U1010-49: CONTROL UNIT(CAN) [INTERNAL ELECTRONIC ERROR]
U1321-55: CONFIG ERROR [NOT CONFIGURED]
- U1000-01: CAN COMM CIRCUIT [ELECTRICAL MALFUNCTION]
| DTC | CONSULT display | Reference | |
|---|---|---|---|
| — | No DTC is detected. Further testing may be required. |
— | |
| U1000-01 | CAN COMM CIRCUIT | [ELECTRICAL MALFUNCTION] | DTC Description |
| U1010-49 | CONTROL UNIT(CAN) | [INTERNAL ELECTRONIC ERROR] | DTC Description |
| U1321-55 | CONFIG ERROR | [NOT CONFIGURED] | DTC Description |
| B2600-46 | CONFIG ERROR | [CALIB/PRMTER MEMORY ERROR] | DTC Description |
Was this page helpful?