Engine Oil
ENGINE OIL LEVEL
Check that the engine oil level is within the range as indicated on the dipstick.
If it is out of range (A), add engine oil as necessary until the dipstick indicates the correct level.
ENGINE OIL APPEARANCE
Check engine oil for white milky appearance or excessive contamination.
If engine oil becomes milky, it is highly probable that it is contaminated with engine coolant. Repair or replace damaged parts.
ENGINE OIL LEAKS
Check for engine oil leaks around the following areas:
Oil pan
Oil pan drain plug
Oil pressure switch
Oil filter
Oil cooler
Intake valve timing control cover
Front timing chain cover
Mating surface between cylinder block and cylinder head
Mating surface between cylinder head and rocker cover
Front oil seal
Rear oil seal
ENGINE OIL PRESSURE CHECK
Check the engine oil level. Refer to ENGINE OIL LEVEL.
Remove fender protector side cover. Refer to Exploded View.
Disconnect the harness connector from the oil pressure switch. Remove oil pressure switch using suitable tool and install suitable tools (A/B).

Start the engine and warm it up to normal operating temperature.
Check oil pressure with engine running under no-load, using suitable tool.
| Engine oil pressure | : Refer to Oil Pressure. |
After the inspections, install the oil pressure switch using suitable tool as follows:Remove the old sealant adhering to oil pressure switch and engine. Apply thread sealant and tighten the oil pressure switch to specification.
Use Genuine High Performance Thread Sealant, or equivalent. Refer to Recommended Chemical Products and Sealants.
| Oil pressure switch | : Refer to Exploded View. |
Install fender protector side cover. Refer to Exploded View.
Prolonged and repeated contact with used engine oil may cause skin cancer; try to avoid direct skin contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
Position the vehicle so it is level on the hoist.
Warm up the engine and check for engine oil leaks from the engine.
Stop engine and wait for 10 minutes.
Remove the oil pan drain plug (1) and oil filler cap.

| : Front |
Drain the engine oil.
Install the oil pan drain plug (1) with a new washer and refill the engine with new engine oil.
| Oil specification and viscosity | : Refer to Engine Oil Recommendation. |
Warm up the engine and check around the oil pan drain plug and oil filter for oil leaks.
Stop engine and wait for 10 minutes.
Check the engine oil level using the oil level gauge.