Brakes

Excessive Operation Frequency

3steps
~18min
2/5difficulty
Done 0 of 3
Diagnosis Procedure

VDC function, TCS function, ABS function, EBD function, brake assist function or hill start assist function operates in excessive operation frequency.

CHECK BRAKING FORCE

Check brake force using a brake tester.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Check brake system.

CHECK FRONT AND REAR AXLE

Check that there is no excessive looseness in front and rear axle.

Refer to Inspection (front) or Inspection (rear).

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK WHEEL SENSOR

Check wheel sensor.

  • Check installation and damage of wheel sensor.

  • Check connection of wheel sensor harness connector.

  • Check terminal of wheel sensor harness connector.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair installation or replace wheel sensor.

  • Front wheel sensor: Refer to Removal and Installation.

  • Rear wheel sensor: Refer to Removal and Installation.

CHECK SENSOR ROTOR

Check that there is no looseness, damage or foreign material on sensor rotor.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair installation or replace sensor rotor.

  • Front sensor rotor: Refer to Removal and Installation - Front Sensor Rotor.

  • Rear sensor rotor: Refer to Removal and Installation - Rear Sensor Rotor.

CHECK THAT WARNING LAMP TURNS OFF

Check that ABS warning lamp, brake warning lamp and VDC warning lamp turn OFF approximately 1 second after key switch is turned ON and stay in OFF status during driving.

Is the inspection result normal?

YES>>

Normal

NO>>

GO TO 6.

PERFORM THE SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch OFF → ON.

  2. Repeat step 1 two or more times.

  3. Select “Self Diagnostic Result” mode of “ABS”.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

Inspection End.