Safety—Seats, seat belts and supplemental restraint system

Fastening the seat belts

4steps
~24min
2/5difficulty
Done 0 of 4
  1. Adjust the seat. For additional information, refer to “Seats” in this section.
    Nissan Murano. Fastening the seat belts
    Nissan Murano. Fastening the seat belts

    Power front seat (if so equipped)

  2. Slowly pull the seat belt out of the retractor and insert the tongue into the buckle Nissan Murano. Fastening the seat belts until you hear and feel the latch engage.
    • The retractor is designed to lock during a sudden stop or on impact. A slow pulling motion permits the seat belt to move and allows you some freedom of movement in the seat.
    • If the seat belt cannot be pulled from its fully retracted position, firmly pull the belt and release it. Then smoothly pull the belt out of the retractor.
    Nissan Murano. Fastening the seat belts
  3. Position the lap belt portion low and snug on the hips Nissan Murano. Fastening the seat belts as shown.
  4. Pull the shoulder belt portion toward the retractor to take up extra slack Nissan Murano. Fastening the seat belts . Be sure the shoulder belt is routed over your shoulder and across your chest.
    Nissan Murano. Fastening the seat belts

The front passenger seat and the rear seating positions’ three-point seat belts have two modes of operation:

  • Emergency Locking Retractor (ELR)
  • Automatic Locking Retractor (ALR)

The ELR mode allows the seat belt to extend and retract to allow the driver and passengers some freedom of movement in the seat. The ELR locks the seat belt when the vehicle slows down rapidly or during certain impacts.

The ALR mode (child restraint mode) locks the seat belt for child restraint installation.

When the ALR mode is activated, the seat belt cannot be extended again until the seat belt tongue is detached from the buckle and fully retracted. The seat belt returns to the ELR mode after the seat belt fully retracts. For additional information, refer to “Child restraints” in this section.

The ALR mode should be used only for child restraint installation. During normal seat belt use by an occupant, the ALR mode should not be activated. If it is activated, itmaycause uncomfortable seat belt tension. It can also change the operation of the front passenger air bag. For additional information, refer to “Front passenger air bag and status light” in this section.