Suspension

Front Stabilizer

~2min read
Exploded View
1. Stabilizer 2. Front suspension member 3. Stabilizer connecting rod
4. Stabilizer bushing 5. Stabilizer clamp
Removal and Installation

REMOVAL

Remove front wheels and tires using power tool. Refer to Removal and Installation.

For AWD Nissan Murano vehicles, remove heat insulator.

For AWD vehicles, remove rear propeller shaft. Refer to Removal and Installation.

Remove cotter pin from outer socket (LH).

Loosen outer socket nut (LH) and separate outer socket (LH) from steering knuckle using suitable tool.

Remove outer socket nut (LH) and separate outer socket (LH) from steering knuckle.

Remove front exhaust tube. Refer to Exploded View.

For FWD Nissan Murano vehicles, remove engine rear mount bracket. Refer to Exploded View.

Remove bolt (A) and separate steering intermediate shaft (1) from steering gear (2).

Remove steering gear heat shield.

Remove steering gear bolts. Refer to Exploded View.

Position steering gear forward.

Remove stabilizer connecting rod upper nuts (A) from front coil spring and struts (LH/RH).

Remove stabilizer connecting rod lower nuts (A) from stabilizer, and remove stabilizer connecting rods (LH/RH).

Remove bolts () from stabilizer clamps, and then remove stabilizer clamps and stabilizer bushings from front suspension member.

Remove stabilizer from (LH) side of Nissan Murano vehicle.

INSTALLATION

Installation is in reverse order of removal.

  • Install stabilizer clamp so that notch (A) is facing front of vehicle ().

  • Install stabilizer bushing so that slit (B) is facing front of Nissan Murano vehicle ().

  • Check wheel alignment. Refer to Inspection.

  • Adjust neutral position of steering angle sensor. Refer to Description.