Body Exterior, Doors, Roof & Vehicle Security

Inspection and Adjustment. Additional Service When Replacing Control Unit

13steps
~78min
3/5difficulty
Done 0 of 13
Special Repair Requirement

INITIALIZATION PROCEDURE

Moonroof/Sunshade

If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal:

  1. Ignition switch ON.

  2. Move the moonroof glass and sunshade to the flush position. Release the switch.

  3. Press and hold the moonroof close switch. After 10 seconds, both the moonroof glass and sunshade will move to the mechanical lock position. Then, after a short mechanical lock (about 400ms), the moonroof glass and sunshade will pull back a short distance. Release the moonroof close switch.

  4. Press and hold the moonroof close switch. The moonroof glass and sunshade both move to full open and then back to the flush position. Once both have released flush, release the moonroof close switch.

  5. Verify moonroof and sunshade operation by tilting the moonroof glass to vent, opening and closing the moonroof and sunshade.

ANTI-PINCH FUNCTION

Moonroof

  1. Fully open the moonroof to the full open position.

  2. Place a piece of wood at the fully closed position.

  3. Close the moonroof completely with auto-slide close function.

  4. Moonroof should make contact and then tilt up or travel in reverse for 7.87 in. (200mm).

Sunshade

  1. Open the sunshade to the full open position.

  2. Place a piece of wood at the fully closed position.

  3. Close the sunshade completely with auto-slide close function.

  4. Sunshade should make contact and then travel in reverse for 3.94 in. (100mm).