Body Interior

Lh Seat

~5min read
Seatback

DISASSEMBLY

Remove the LH seat. Refer to Removal and Installation.

Remove the LH seat cushion. Refer to Seat Cushion.

Release clips and remove seatback board (1).

: Clip

Remove the headrest (LH).

Reach up behind the seatback pad, release the headrest holder locks as shown and remove the headrest holders.

Release the seatback heater harness connector (if equipped) from attachment.

Release the seat back Side air bag harness connector from attachment.

Remove screw and reclining device outer cover (LH) (if necessary).

Remove screw, then release clip and pawls and remove reclining device outer cover (RH).

Remove screw, then release clip and remove recline device inner cover (RH) from seat frame assembly (if necessary).

Remove latch bracket to seatback assembly bolts.

Remove recline device assembly to seatback assembly bolts.

Slide seatback assembly away from recline device assembly to release and remove.

ASSEMBLY

Assembly is in the reverse order of disassembly.

  • When installing the front seatback assembly, tighten the bolts to specification. Refer to Exploded View.

Seat Cushion

DISASSEMBLY

Remove the LH seat cushion. Refer to Seat Cushion.

Release J-hooks (A), then hook and loop fastener (D)

Release string (B) from seat cushion frame and route seat cushion heater harness through seat cushion trim.

Remove hog rings using a using a suitable tool and remove seat cushion pad and trim as an assembly.

: Hog ring

Separate the seat cushion trim (1) from the seat cushion pad.

Pull seat cushion trim up at front center to release hook and loop fasteners (A).

: Front

Remove hog rings and separate the seat cushion trim from the seat cushion pad.

: Hog ring

ASSEMBLY

Assembly is in the reverse order of disassembly.

  • Install new hog rings on the seat cushion trim in original positions.

  • Use only one hog ring in each designated location.

  • Make sure hog rings are correctly fastened around both the seat cushion trim and seat cushion pad wires.

  • Use NISSAN standard hog rings and tools to assemble.

  • Make sure hook and loop fastener is pressed into place after seat cushion trim is assembled.

  • Smooth out all wrinkles during assembly.