Body Exterior, Doors, Roof & Vehicle Security
Outside Handle
In this manual: Body Exterior, Doors, Roof & Vehicle Security
~1min read
REMOVAL
Fully close front door glass.
Remove front door finisher. Refer to Removal and Installation.
Remove front door vapor barrier.
Remove door side grommet (1), and remove bolt from grommet hole (2).

Separate door key cylinder rod (LH only) (1) from door key cylinder assembly (LH only) (2).

While pulling (1) outside handle, remove (2) door key cylinder assembly (LH side) or outside handle escutcheon (RH side).

While pulling outside handle (1), slide toward rear of Nissan Murano vehicle to remove outside handle.

Remove front gasket and rear gasket.
Slide outside handle bracket toward rear of Nissan Murano vehicle to remove.

Disconnect outside handle cable from outside handle bracket and remove.
INSTALLATION
Installation is in the reverse order of removal.
Was this page helpful?