Electrical & Power Control

Power Consumption Control System

~2min read
System Description

SYSTEM DIAGRAM

INPUT SIGNAL AND OUTPUT SIGNAL

Major signal transmission between each unit via communication lines is shown in the following table:

Component partsSignal description
IPDM E/R
  • Each unit transmits the sleep-ready signal (ready) to BCM when all of the CAN sleep conditions are fulfilled.

  • Each unit transmits the sleep-ready signal (not-ready) to BCM when all of the CAN sleep conditions are fulfilled.

  • Each unit receives the sleep wake up signal (sleep) from BCM via CAN communication.

  • Each unit receives the sleep wake-up signal (wake-up) from BCM via CAN communication.

Combination meter
BCM
  • BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.

  • BCM transmits the sleep wake-up signal (wake-up) to each unit when all of the CAN sleep conditions are fulfilled.

  • BCM receives the sleep-ready signal (ready) from each unit via CAN communication.

  • BCM receives the sleep-ready signal (not-ready) from each unit via CAN communication.

DESCRIPTION

  • IPDM E/R incorporates a power consumption control function that reduces the power consumption according to the Nissan Murano vehicle status.

  • IPDM E/R changes its status (control mode) with the sleep wake up signal received from BCM via CAN communication.

    Normal mode (wake-up)

    • CAN communication is normally performed with other control units.

    • Individual unit control by IPDM E/R is normally performed.

    Low power consumption mode (sleep)

    • Low power consumption control is active.

    • CAN transmission is stopped.

SLEEP MODE ACTIVATION

  • IPDM E/R judges that the sleep-ready conditions are fulfilled when the ignition switch is OFF and none of the conditions below are present. Then it transmits a sleep-ready signal (ready) to BCM via CAN communication.

    • Front wiper fail-safe operation

    • Outputting signals to actuators

    • Switches or relays operating

    • Auto active test is starting

    • Emergency OFF

    • Output requests are being received from control units via CAN communication.

  • IPDM E/R stops CAN communication and enters the low power consumption mode when it receives a sleep wake up signal (sleep) from BCM and the sleep-ready conditions are fulfilled.

WAKE-UP OPERATION

  • IPDM E/R changes from the low power consumption mode to the normal mode when it receives a sleep wake-up signal (wake up) from BCM or any of the following conditions is fulfilled. In addition, it transmits a sleep-ready signal (not-ready) to BCM via CAN communication to report the CAN communication start.

    • Ignition switch ON

    • An output request is received from a control unit via CAN communication.

IGNITION BATTERY SAVER LOGIC

If ignition switch ON for a period of time with the engine OFF, the IPDM E/R and BCM turn OFF to save the battery.