Cruise Control & Driver Assistance
Power Supply and Ground Circuit
In this manual: Cruise Control & Driver Assistance
3steps
~18min
2/5difficulty
Done 0 of 3
Regarding Wiring Diagram information, refer to Wiring Diagram.
CHECK FUSES
Check that the following fuse is not blown:
| Signal name | Fuse No. |
|---|---|
| Ignition power supply | 29 (10A) |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK ADAS CONTROL UNIT POWER SUPPLY CIRCUIT
Check voltage between ADAS control unit harness connector and ground.
| Terminal | Condition | Voltage (Approx.) |
||
| (+) | (–) | |||
| ADAS control unit | Ground | Ignition switch | ||
| Connector | Terminal | |||
| M182 | 16 | OFF | 0 V | |
| ON | Battery voltage | |||
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair the ADAS control unit power supply circuit.
CHECK ADAS CONTROL UNIT GROUND CIRCUIT
Turn the ignition switch OFF.
Disconnect the ADAS control unit connector.
Check for continuity between ADAS control unit harness connector and ground.
ADAS control unit Ground Continuity Connector Terminal M182 2 Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair the ADAS control unit ground circuit.
Was this page helpful?