Electrical & Power Control

Precaution. Precautions

~1min read
Precautions for Trouble Diagnosis
  • Never apply 7.0 V or more to the measurement terminal.

  • Use a tester with open terminal voltage of 7.0 V or less.

  • Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness.

Precautions for Harness Repair
  • Solder the repaired area and wrap tape around the soldered area.

  • Bypass connection is never allowed at the repaired area.

  • Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.