Engine

S Terminal Circuit

11steps
~66min
3/5difficulty
Done 0 of 11
Diagnosis Procedure
  1. Remove fuel pump fuse.

  2. Crank or start the engine (where possible) until the fuel pressure is released.

CHECK STARTER MOTOR MAGNETIC SWITCH CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect starter motor connector.

  3. Shift transmission into P (Park) or N (Neutral).

  4. Check voltage between starter motor connector and ground with the ignition switch in START.

    (+)(—)Condition

    Voltage

    (Approx.)
    Starter motor
    ConnectorTerminal
    F28 S Ground Ignition switch in START position Battery voltage

Is the inspection result normal?

YES>>

Magnetic switch circuit is OK. Further inspection is necessary. Refer to Work Flow (With 165-DSS-5000P), or Work Flow (Without 165-DSS-5000P).

NO>>

GO TO 2.

CHECK CONNECTOR

  1. Ignition switch OFF.

  2. Check the IPDM E/R connector F17 and starter motor connector F28 for damage, bent pins and loose connections.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Disconnect IPDM E/R connector and starter motor connector.

  2. Check continuity between starter motor connector and IPDM E/R connector.

    Starter motorIPDM E/RContinuity
    ConnectorTerminalConnectorTerminal
    F28 S F17 51 Yes
  3. Check continuity between starter motor connector and ground.

    Starter motor—Continuity
    ConnectorTerminal
    F28 S Ground No

Is the inspection result normal?

YES>>

Further inspection is necessary. Refer to Work Flow (With 165-DSS-5000P), or Work Flow (Without 165-DSS-5000P).

NO>>

Repair the harness.