Driver Information & Multimedia

Sonar Sensor

~3min read
Removal and Installation

REAR SONAR SENSOR OUTER

Release pawls using suitable tool and remove rear sonar sensor (1).

:Pawl

Disconnect the harness connector from rear sonar sensor.

Remove the rear sonar sensor finisher from the rear bumper fascia (if necessary).

Installation is in the reverse order of removal.

REAR SONAR SENSOR INNER

Remove rear bumper fascia. Refer to Exploded View.

Release pawls using suitable tool and remove rear sonar sensor (1).

:Pawl

Disconnect the harness connector from rear sonar sensor.

Remove the rear sonar sensor finisher from the rear bumper fascia (if necessary).

Installation is in the reverse order of removal.

FRONT SONAR SENSOR OUTER

Partially remove front portion of front fender protector. Refer to Exploded View.

Release pawls using suitable tool and remove front sonar sensor (1).

:Pawl

Disconnect the harness connector from front sonar sensor.

Remove the front sonar sensor finisher from the front bumper fascia (if necessary).

Installation is in the reverse order of removal.

FRONT SONAR SENSOR INNER

Remove front under cover. Refer to Removal and Installation.

Disconnect the harness connector (A) from the front sonar sensor inner (1).

:Pawl

Using a suitable tool, release pawls from the front sonar sensor inner and remove.

Remove the front sonar sensor finisher from the bumper fascia (if necessary).

(A) : Horizontal position
(a) : ± 10°

Install front sonar sensor inner to sensor finisher.

Degrease and clean the inner side of the front bumper fascia and apply adhesion promoter to the area shown (A).

Let the adhesion promoter dry for more than three minutes and peel off the double sided tape film, and then taking precautions not to contact the bumper with the double sided tape (A), bend the front sonar sensor inner finisher in the direction shown.

Match the part of the front sonar sensor inner (A) shown in the figure to the sensor installing hole of the front bumper fascia.

Remove the front sonar sensor inner from the sensor finisher and press the adhesion face (A) for more than two seconds to securely bond the front sonar sensor inner finisher to front bumper fascia inner.

Target pressure : 50.0 N (5.1 kg, 11.24 lb)

Install front sonar sensor inner to the sensor finisher.

Shake the part of the front sonar sensor inner finisher (A) up and down and then right and left to confirm that the finisher has been installed (bonded) firmly.

Connect the harness connector to the front sonar sensor inner.