System Setting
DESCRIPTION
If the temperature felt by the customer is different from the front air flow temperature controlled by the temperature setting, the A/C auto amp. control temperature can be adjusted to compensate for the temperature setting.
HOW TO SET
CONSULT
Select “TEMP SET CORRECT” in “Work support” mode of “HVAC”.
| Work support items | Display (°C) | Display (°F) |
|---|---|---|
| TEMP SET CORRECT | 3.0 | 6 |
| 2.5 | 5 | |
| 2.0 | 4 | |
| 1.5 | 3 | |
| 1.0 | 2 | |
| 0.5 | 1 | |
| 0 (initial status) | 0 (initial status) | |
| −0.5 | −1 | |
| −1.0 | −2 | |
| −1.5 | −3 | |
| −2.0 | −4 | |
| −2.5 | −5 | |
| −3.0 | −6 |
DESCRIPTION
In FOOT mode, the air blowing to DEF can change ON/OFF.
HOW TO SET
CONSULT
Select “BLOW SET” in “Work support” mode of “HVAC”.
| Work support items | Display | Defroster door position | |
|---|---|---|---|
| Auto control | Manual control | ||
| BLOW SET | Mode1 | OPEN | CLOSE |
| Mode2 (initial status) | OPEN | OPEN | |
| Mode3 | CLOSE | OPEN | |
| Mode4 | CLOSE | CLOSE | |
DESCRIPTION
If ignition switch OFF while the intake switch is set to OFF (fresh air intake), “Perform the memory” or “Do not perform the memory” of intake switch OFF (fresh air intake) condition can be selected.
If “Perform the memory” was set, the intake switch will be OFF (fresh air intake) when ignition switch ON again.
If “Do not perform the memory” was set, the air inlets will be controlled automatically when ignition switch ON again.
HOW TO SET
CONSULT
Select “FRE MEMORY SET” in “Work support” mode of “HVAC”.
| Work support items | Display | Setting |
|---|---|---|
| FRE MEMORY SET | WITHOUT | Perform the memory of manual FRE |
| WITH (initial status) | Do not perform the memory of manual FRE (auto control) |
DESCRIPTION
If ignition switch OFF while the intake switch is set to ON (recirculation), “Perform the memory” or “Do not perform the memory” of intake switch ON (recirculation) condition can be selected.
If “Perform the memory” was set, the intake switch will be ON (recirculation) when ignition switch ON again.
If “Do not perform the memory” was set, the air inlets will be controlled automatically when ignition switch ON again.
HOW TO SET
CONSULT
Select “REC MEMORY SET” in “Work support” mode of “HVAC”.
| Work support items | Display | Setting |
|---|---|---|
| REC MEMORY SET | WITHOUT (initial status) | Perform the memory of manual REC |
| WITH | Do not perform the memory of manual REC (auto control) |
DESCRIPTION
Set the target evaporator temperature upper limit.
HOW TO SET
CONSULT
Select “TARGET EVAPORATOR TEMP UPPER LIMIT SETTING” in “Work support” mode of “HVAC”.
| Work support items | Display |
|---|---|
| TARGET EVAPORATOR TEMP UPPER LIMIT SETTING | Initial Setting |
| Low | |
| Middle | |
| High |