Bodywork
Tailgate
In this manual: Bodywork
~1min read

REMOVAL

After removing the trim and disconnecting the wiring, remove the balancers then the mounting screws (A) in the rear roof crossmember (preferably carried out by two people).
INSTALLATION
Refit in reverse order of removal and refer to chapter 40 (opening clearances) to carry out adjustments correctly.
ADJUSTMENT
Height and tilt adjustment is made by shimming under the mounting screws (A).
Flushness adjustment is made by moving the same screws in their mounting holes.
Test yourself
A quick Renault Kangoo quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?