Grand Volume add-on roof

INTRODUCTION

Replacing this part is a basic operation for a side impact.

In the operation described below, you will only find descriptions of the joints specific to the part concerned.

Information on additional parts is covered in their respective chapters (see contents).

M.P.R. PART COMPOSITION

Supplied with gallery spacers and plugs.

PARTS CONCERNED (thickness in mm):

1. 1

   Add-on roof 0.7

2. 2

   Add-on side panel 0.8

3. 3

   Base body roof 0.8

4. 4

   Rear roof cross member 0.8

5. 5

   Gallery spacer 15

6. 6

   Rear upper corner reinforcement 1

REMOVAL - REFITTING

Ø 5 mm bead

Between panels (1) and (2)

Ø 5 mm bead

Between panels (1) and (3)

Ø 5 mm bead

A Between panels (1) and (2)

Ø 5 mm bead

B Between panel (1) and part (5)

Ø 5 mm bead

Between panels (1) and (4)

Ø 5 mm bead

Apply a thin bead of adhesive to the spacer at (1), tighten by hand until the two panels are clamped, then finish with a light tightening with a spanner - tightening torque 2.37 daN.m.

Apply an adhesive bead at (2) before refitting the add-on roof.

Example of clamping method for refitting the add-on roof.