Rear door trim panel

NOTE: When replacing a door or carrying out bodywork, refer to chapter 47A.

REMOVAL

Remove the cover and the screw from the window regulator plate.

Release the plate.

Remove the cover and the screw (A) from the door opening control.

Unclip the cover securing the door opening control cable using a flat-blade screwdriver.

Unclip the trim panel access cover using the trim clip pliers (protecting the trim panel).

Open the access cover.

Hold it open (with masking tape).

Position the window to access the retaining clip (B).

Release the lug (C) by pulling the window upwards using a flat-blade screwdriver.

Lock the window in the raised position.

Remove:

• the screws (D),
• the three window regulator motor screws.

NOTE: The window regulator motor and the harness are attached to the trim panel.

1. 1
   Lift the trim panel upwards and remove it.
2. 2
   Spread it apart to release the window regulator drive carrier from the door shell at the bottom.
3. 3
   Pull the trim panel downwards.

   

Disconnect the centre pillar connector.

Release the clips (E) and remove the assembly "trim panel - window regulator motor - harness".

REMOVING THE WINDOW REGULATOR MOTOR

Disconnect the window regulator motor.

Unclip the two window regulator drive carrier fixings from the trim panel.

Remove the window regulator motor.

INSTALLATION

NOTE: When replacing, the trim panel is supplied on its own.

For this reason, note the routing of the harness.

Clip the motor assembly onto the trim panel.

Position the assembly on the door.

Connect the connector to the centre pillar.

1. 1
   Insert the drive carriers into the door shell at the top.
2. 2
   Fit the trim panel at the bottom, taking care to insert the window regulator drive carriers.
3. 3
   Lower the trim panel.

   

Position:

• the lower screw (F) and the upper screws (I),
• the screws (J).

Refit in the reverse order of removal.