Renault Megane Quiz
Trim and upholstery

Front door trim panel

In this manual: Trim and upholstery
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
6steps
~36min
2/5difficulty
Done 0 of 6

NOTE: When replacing a door or carrying out bodywork, refer to chapter 47A.

REMOVAL

Garniture de porte avant

Unclip the interior cover.

Garniture de porte avant

Protect the trim (e.g. with a putty knife) and, using the clip removal pliers, unclip the window regulator plate.

Disconnect the connectors.

Garniture de porte avant

Unclip the door pocket.

CAUTION: Do not pull on the door pocket flap.

Garniture de porte avant

Unclip the pull handle cover.

Disconnect the mirror control connector.

Garniture de porte avant

Remove the screws (A).

Garniture de porte avant

Remove the cover and the screw (B) from the door opening control.

Garniture de porte avant

Unclip the opening control cable retaining cover using a flat-blade screwdriver.

Garniture de porte avant

Unclip the trim panel access cover using the trim clip pliers (protecting the trim panel).

Open the access cover.

Hold it open (with masking tape).

Garniture de porte avant

Position the window to access the two retaining clips (C).

Garniture de porte avant

Release the lug (D) by pulling the window upwards.

To make the right-hand clip easier to reach, unclip the speaker grille.

Garniture de porte avant

Remove the window.

Garniture de porte avant

Disconnect the lock connector (E) and the two connectors of the handle module (if the vehicle is fitted with hands-free access).

Remove the screws (F).

NOTE: The window regulator motor and the harness are attached to the trim panel.

Garniture de porte avant
  1. Lift the trim panel upwards and remove it.
  2. Spread it apart to release the window regulator drive carriers from the door shell at the bottom.
  3. Pull the trim panel downwards.
    Garniture de porte avant

Disconnect the front pillar connector.

Unclip the clip (G) and remove the assembly "trim panel - window regulator motor - harness".

REMOVING THE WINDOW REGULATOR MOTOR

Garniture de porte avant

Remove:

  • the three motor fixings (H),
  • the speaker screws and remove the speaker.
Garniture de porte avant

Disconnect the window regulator motor.

Unclip the four window regulator drive carrier fixings from the trim panel.

Remove the window regulator motor.

INSTALLATION

NOTE: When replacing, the trim panel is supplied on its own.

For this reason, note the routing of the harness.

Garniture de porte avant

Clip the drive carriers onto the trim panel.

Fit the window regulator motor.

Position the assembly on the door.

Connect the connector to the front pillar.

  1. Insert the drive carriers into the door shell at the top.
  2. Fit the trim panel at the bottom, taking care to insert the window regulator drive carriers.
  3. Lower the trim panel.
    Garniture de porte avant

Position the two lower screws (I) and the upper screws (J).

Refit in the reverse order of removal.

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.