Gearshift shaft oil seal / bearing removal and installation

1. 1
   Remove the gearshift shaft. Refer to “gearshift shaft / gearshift cam plate removal and installation” .
2. 2
   Remove the gearshift shaft oil seal (1).

   

3. Remove the bearings (2) and (3) with the special tools.

Special tool (a): 09921–20210 (bearing remover
(12 mm)) (b): 09930–30104 (rotor remover
sliding shaft)

Install the oil seal and bearing in the reverse order of removal. Pay attention to the following points:

Caution the removed oil seal and bearings must be replaced with new ones.

• Install the bearings with the special tool.

Note the stamped mark side of gearshift shaft bearing faces outside.

Special tool (a): 09913–70210 (bearing
installing set (10 – 75 Ф))

• Install the oil seal with the special tool.

Special tool (a): 09913–70210 (bearing
installing set (10 – 75 Ф))

• Apply grease to the oil seal lip.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)