Accessory Meter

Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

3. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

4. REMOVE HEATER CONTROL ASSEMBLY

5. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (for Radio and Display Type)

6. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)

7. REMOVE ACCESSORY METER ASSEMBLY

(a) Remove the 2 screws.

(b) Disconnect the connector to remove the accessory meter assembly as shown in the illustration.

Disassembly DISASSEMBLY PROCEDURE

1. REMOVE CENTER DISPLAY GLASS

(a) Detach the 8 claws and remove the display glass.

Reassembly REASSEMBLY PROCEDURE

1. INSTALL CENTER DISPLAY GLASS

(a) Attach the 8 claws to install the display glass.

Installation INSTALLATION PROCEDURE

1. INSTALL ACCESSORY METER ASSEMBLY

(a) Connect the connector.

(b) Install the accessory meter assembly with the 2 screws.

2. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)

3. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (for Radio and Display Type)

4. INSTALL HEATER CONTROL ASSEMBLY

5. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

6. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).