Inspection

1. INSPECT TIRES

(a) Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure (Unloaded Vehicle):

(b) Using a dial indicator, check the tire runout. Standard tire runout: 3.0 mm (0.118 in.) or less

2. ROTATE TIRES

HINT:

Rotate the tires as shown in the illustration.

Front

3. INSPECT WHEEL BALANCE

(a) Check and adjust the off-the-car balance. Text in Illustration *a P245/60R20 107H *b P265/70R17 113S

(b) If necessary, check and adjust the on-the-car balance.

Standard Imbalance after Adjustment:

NOTICE:

• The imbalance after adjustment value is the conversion value at the rim flange position.
• Using a cleaning detergent, remove dirt, oil and water from the surface where the balance weight is to be adhered.
• Do not touch the adhesive surface of the tape.
• Attach a sticking type balance weight to the flat surface (A) shown in the illustration.

  Width (A):

  25 mm (0.984 in.)

• Push the balance weight with your finger so that it securely adheres to the position.
• Do not reuse the balance weight.

4. INSPECT FRONT AXLE HUB

(a) for 2WD:

Inspect the front axle hub (See page ).

(b) for 4WD:

Inspect the front axle hub (See page ).

5. INSPECT REAR AXLE SHAFT

(a) Inspect the rear axle shaft (See page ).