Inspection

INSPECTION PROCEDURE

1. INSPECT FRONT DOOR LOCK ASSEMBLY LH

(a) Check the door lock motor operation.

(1) Apply battery voltage to the motor connector and check the operation of the door lock.

Text in Illustration

*a	Lock	*b	Unlock
*c	Component without harness connected (Front Door Lock Assembly LH)	-	-

OK:

Measurement Condition	Specified Condition
Battery positive (+) → 4 (L) Battery negative (-) → 1 (UL)	Lock
Battery positive (+) → 1 (UL) Battery negative (-) → 4 (L)	Unlock

• If the result is not as specified, replace the front door lock assembly.

(b) Check the detection switch.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
8 (LSSR) - 7 (E)	Lock	10 kΩ or higher
8 (LSSR) - 7 (E)	Unlock	Below 1 Ω

• If the result is not as specified, replace the front door lock assembly.

(c) Check the door lock and unlock switch.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a	Lock	*b	Off
*c	Unlock	*d	Component without harness connected (Front Door Lock Assembly LH)

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
9 (L) - 7 (E)	Lock	Below 1 Ω
9 (L) - 7 (E) 10 (UL) - 7 (E)	Off	10 kΩ or higher
10 (UL) - 7 (E)	Unlock	Below 1 Ω

• If the result is not as specified, replace the front door lock assembly.

2. INSPECT FRONT DOOR LOCK ASSEMBLY RH

(a) Check the door lock motor operation.

(1) Apply battery voltage to the door lock motor connector and check the operation of the door lock.

Text in Illustration

*a	Unlock	*b	Lock
*c	Component without harness connected (Front Door Lock Assembly RH)	-	-

OK:

Measurement Condition	Specified Condition
Battery positive (+) → 4 (L) Battery negative (-) → 1 (UL)	Lock
Battery positive (+) → 1 (UL) Battery negative (-) → 4 (L)	Unlock

• If the result is not as specified, replace the front door lock assembly.

(b) Check the detection switch.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
7 (LSSR) - 8 (E)	Lock	10 kΩ or higher
7 (LSSR) - 8 (E)	Unlock	Below 1 Ω

• If the result is not as specified, replace the front door lock assembly.