Installation

INSTALLATION CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH

NOTICE:

When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.

(a) Align the claws with the seat belt positioning holes and install the retractor of the seat belt with the nut and bolt as shown in the illustration.

HINT:

First install the bolt, and then install the nut.

Torque:

for bolt :

7,5 N·m {76 kgf·cm, 66 in·lbf}

for nut :

42 N·m {428 kgf·cm, 31 ft·lbf}

Text in Illustration

*1	Bolt
*2	Nut

2. INSTALL REAR SEAT SHOULDER BELT GUIDE

3. INSTALL REAR SEATBACK EDGE PROTECTOR

4. INSTALL SEATBACK COVER WITH PAD

5. INSTALL REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY

6. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY LH

7. INSTALL REAR SEATBACK COVER

8. INSTALL REAR SEAT SHOULDER BELT COVER

9. INSTALL SEAT BELT ANCHOR COVER CAP

10. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH

11. INSTALL RECLINING ADJUSTER KNOB CAP LH

12. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

(a) Install the inner belt and connect the 3 point type belt anchor with the bolt.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

NOTICE:

Do not allow the anchor part of the anchor plate sub-assembly to overlap the protruding parts of the seatback frame.

Text in Illustration

*1	Protruding Part

13. INSTALL CENTER SEATBACK ASSEMBLY

14. INSTALL SEAT CUSHION COVER WITH PAD

15. INSTALL REAR SEATBACK LOCK STRIKER COVER LH

16. INSTALL REAR SEAT CUSHION MOULDING LH

17. INSTALL CENTER SEAT HINGE COVER RH

18. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

19. INSTALL REAR SEAT UPPER RECLINING COVER LH

20. INSTALL REAR NO. 1 SEAT ASSEMBLY LH

(a) Install the rear No. 1 seat assembly LH (See page ).