Rear Differential Lock Position Switch

1. INSPECT REAR DIFFERENTIAL LOCK POSITION SWITCH

(a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 1 (GND) - 2 (+B) Pushed Below 1 Ω Released 100 kΩ or higher Text in Illustration *a Component without harness connected (Rear Differential Lock Position Switch) *b Pushed *c Released If the result is not as specified, replace the rear differential lock position switch.

1. REMOVE REAR DIFFERENTIAL LOCK POSITION SWITCH

(a) Remove the rear differential lock position switch (See page ).

1. INSTALL REAR DIFFERENTIAL LOCK POSITION SWITCH

(a) Install the rear differential lock position switch (See page ).