Washer Nozzle(for Front Side)

Components COMPONENTS ILLUSTRATION
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE

1. INSPECT WASHER NOZZLE SUB-ASSEMBLY

(a) With the engine running, check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.

Text in Illustration

*1	Ceramic Line	-	-
*a	Upper Limit	*b	Standard
*c	Lower Limit	-	-
	Washer Fluid Spray Area	-	-

Standard:

Area	Measurement	Area	Measurement
A	254.5 mm (10.0 in.)	B	150 mm (5.91 in.)
C	127.6 mm (5.02 in.)	-	-

If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.

Removal REMOVAL PROCEDURE

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

(a) Using a screwdriver, detach the 2 claws and disconnect the washer nozzle sub-assembly as shown in the illustration. HINT: Tape the screwdriver tip before use. Text in Illustration *1 Protective Tape NOTICE: Be careful not to damage the windshield.

(b) Remove the washer nozzle sub-assembly from the washer hose. NOTICE: Washer nozzles cannot be reused.

Adjustment ADJUSTMENT PROCEDURE

1. REMOVE WASHER NOZZLE SUB-ASSEMBLY

2. ADJUST WASHER NOZZLE SUB-ASSEMBLY

(a) Select a washer nozzle so that the washer fluid spray area is as specified in On-vehicle Inspection. Replace the washer nozzle with the selected one.

Text in Illustration

*1	Available Washer Nozzles	*2	Washer Fluid Spray Angle
*3	Part Number	-	-

3. INSTALL WASHER NOZZLE SUB-ASSEMBLY

Installation INSTALLATION PROCEDURE

1. INSTALL WASHER NOZZLE SUB-ASSEMBLY

(a) Connect a new washer nozzle sub-assembly to the washer hose.

(b) Attach the 2 claws to install the washer nozzle sub-assembly.

2. INSPECT WASHER NOZZLE SUB-ASSEMBLY

3. ADJUST WASHER NOZZLE SUB-ASSEMBLY