Washer Nozzle(for Rear Side)

Components COMPONENTS ILLUSTRATION
On-vehicle Inspection ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT

HINT:

The washer fluid does not spray if the back door and back door glass are not closed.

PROCEDURE

1. INSPECT REAR WASHER NOZZLE

(a) With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

Standard:

Washer fluid hits the windshield in the area shown in the illustration.

Text in Illustration

*1	Ceramic Line	-	-
*a	Wiping Pattern	-	-
	Washer Fluid Spray Area	-	-

Standard:

Area	Measurement	Area	Measurement
A	300.8 mm (11.8 in.)	B	235.1 mm (9.26 in.)
C	110.8 mm (4.36 in.)	D	81 mm (3.19 in.)
E	328.8 mm (12.9 in.)	F	278.2 mm (10.9 in.)
G	230.7 mm (9.08 in.)	H	322.7 mm (12.7 in.)

If the result is not as specified, replace the malfunctioning rear washer nozzle.

Removal REMOVAL PROCEDURE

1. REMOVE REAR SPOILER SUB-ASSEMBLY

(a) Remove the rear spoiler sub-assembly (See page ).

2. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY

3. REMOVE REAR WASHER NOZZLE

(a) Detach the 2 claws.

(b) Disconnect the washer hose and remove the rear washer nozzle.

Adjustment ADJUSTMENT PROCEDURE

1. ADJUST REAR WASHER NOZZLE

(a) Using a screwdriver, adjust the direction of the rear washer nozzle. HINT: Use a thin-bladed screwdriver with a tip approximately 1 mm (0.0394 in.) thick. NOTICE: Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

Installation INSTALLATION PROCEDURE

1. INSTALL REAR WASHER NOZZLE

(a) Connect the washer hose.

(b) Attach the 2 claws to install the rear washer nozzle.

2. INSPECT REAR WASHER NOZZLE

3. ADJUST REAR WASHER NOZZLE

4. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

5. INSTALL REAR SPOILER SUB-ASSEMBLY

(a) Install the rear spoiler sub-assembly (See page ).