Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed and installed or replaced during removal/installation of the blind spot monitor buzzer are shown below.
Procedures Required After Replacement / Removal / Installation of PartsReplaced Part or Performed Procedure | Required Procedure | Effect/Inoperative Function When Required Procedure Is Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
|
Pre-Collision System |
|||
Initialize Back Door Lock |
Initialize Back Door Lock |
CAUTION:
Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.
Click here
![]()
PROCEDURE
1. REMOVE LH FRONT DOOR SILL PLATE
Click here
![]()
2. REMOVE LH FENDER APRON SIDE PANEL
Click here
![]()
3. REMOVE NO. 1 INSTRUMENT PANEL LOWER COVER SUB-ASSEMBLY
Click here
![]()
4. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
![]()
5. REMOVE FUSE BLOCK OPENING COVER
Click here
![]()
6. REMOVE BLIND SPOT MONITOR BUZZER
(a) Using a clip remover, release the clip. |
![]() |
(b) Disconnect the connector to remove the blind spot monitor buzzer.
.gif)
