Reassembly
REASSEMBLY
PROCEDURE
1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder assembly.
HINT:
After bleeding the system, fully tighten the rear disc brake bleeder plug.
2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
(a) Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.
3. INSTALL PISTON SEAL
(a) Apply lithium soap based glycol grease to the entire circumference of a new piston seal.
![]() |
Lithium soap base glycol grease |
(b) Install the piston seal to the rear disc brake cylinder assembly.
NOTICE:
- Take care not to damage the inner surface or the piston seal groove of the rear disc brake caliper.
- Prevent the nut from turning. If the nut turns accidentally, return it to its original position.
4. INSTALL REAR DISC BRAKE PISTON
(a) Apply a thin coat of lithium soap based glycol grease to the entire circumference of a new cylinder boot.
*1 |
Cylinder Boot |
*2 |
Rear Disc Brake Piston |
![]() |
Lithium soap base glycol grease |
(b) Apply a thin coat of lithium soap based glycol grease to the contact surfaces of the rear disc brake piston.
(c) Install the cylinder boot to the rear disc brake piston.
(d) Install the joint portion of the cylinder boot to the grooved portion of the rear disc brake cylinder. NOTICE: Properly install the cylinder boot in the groove of the rear disc brake cylinder. |
|
(e) Install the rear disc brake piston to the rear disc brake cylinder assembly.
NOTICE:
- Install the left rear disc brake cylinder so that its marked parts (A) fit into the recesses of the rear disc brake piston.
- Do not force the rear disc brake piston into the rear disc brake cylinder assembly.
(f) Install the rear disc brake piston to the rear disc brake cylinder assembly.
(g) Make sure the cylinder boot is properly installed in the grooves of the rear disc brake cylinder and the rear disc brake piston. |
|
.png)

