Engine control system

Throttle body assy (2AZ−FE)

15steps
~90min
4/5difficulty
010203040503022N·mlb·ft
Tightening torque found on this page
Done 0 of 15
COMPONENTS
REPLACEMENT
REPLACEMENT
  1. DRAIN ENGINE COOLANT
  2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
  3. REMOVE THROTTLE BODY ASSY
  4. Disconnect the throttle control motor & throttle position connector.

  5. Disconnect the 2 vacuum hoses from the throttle body.

  6. Disconnect the 2 water bypass hoses.

  7. Remove the 4 bolts, fuel pipe support and throttle body.

  8. Remove the gasket.

Remove throttle body assy
Remove throttle body assy
4. INSTALL THROTTLE BODY ASSY

a. Install a new gasket on the intake manifold, as shown in the illustration.

  1. Install the throttle body and fuel pipe support with the 4 bolts. Torque: 30 N·m
  2. Connect the 2 water bypass hoses to the throttle body.

  3. Connect the 2 vacuum hoses to the throttle body.

  4. Connect the throttle control motor & throttle position connector.

  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
  6. ADD ENGINE COOLANT
  7. CHECK FOR ENGINE COOLANT L

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.