Audio & Visual & Telematics

Calibration

~1min read

CALIBRATION

NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the intuitive parking assist system may not operate correctly.

ADJUST INTUITIVE PARKING ASSIST SYSTEM

(a) The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intuitive parking assist system removal/installation are shown below.

HINT:

When the bumper is removed and installed, or when the sensor is removed and installed, the registration is not required. However, if the body part is damaged or deformed due to an accident or contact, etc., and the body part is modified, measurement and registration are required.

Part Name

Operation

Adjustment Item

Proceed to

Clearance warning ECU assembly

Replacement

Update ECU security key

Measurement of ultrasonic sensor detection angle

Bumper type registration

Ultrasonic sensor detection angle registration

Ultrasonic sensor

Replacement

Measurement of ultrasonic sensor detection angle

Ultrasonic sensor detection angle registration

Front bumper assembly

When the front bumper and ultrasonic sensor is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired.

Measurement of Ultrasonic sensor detection angle

Ultrasonic sensor detection angle registration

Rear bumper assembly

When the rear bumper and ultrasonic sensor is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired.

Measurement of Ultrasonic sensor detection angle

Ultrasonic sensor detection angle registration