Power Source & Network

Data List / Active Test

~2min read

DATA LIST / ACTIVE TEST

READ DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) According to the display on the GTS, read the Data List.

Body Electrical > Main Body > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Communication Power Integration No.1

Connection status between semiconductor power integration ECU and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connection

STOP: No connection

This item is displayed but not used

Communication Power Integration No.2

Connection status between No. 2 semiconductor power integration ECU and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connection

STOP: No connection

This item is displayed but not used

Communication Power Integration No.3

Connection status between No. 3 semiconductor power integration ECU and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connection

STOP: No connection

This item is displayed but not used

Communication Power Distribution Box

Connection status between power distribution box assembly and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connection

STOP: No connection

When there is a malfunction, a DTC is stored.