Power Source & Network

How To Proceed With Troubleshooting

~1min read

HINT:

  • Use these procedures to troubleshoot the CXPI communication system.
  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. INSPECT AUXILIARY BATTERY VOLTAGE

(a) Measure the auxiliary battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

NEXT
  1. CHECK POWER INTEGRATION SYSTEM*

(a) Use the GTS to check if the power integration system is functioning normally.

Result

Proceed to

Power integration system DTCs are not output

A

Power integration system DTCs are output

B

B

GO TO POWER INTEGRATION SYSTEM

A
  1. CHECK FOR DTC*

(a) Check for DTCs and make a note of any codes that are output.

(b) Clear the DTCs.

Body Electrical > Main Body > Clear DTCs

(c) Recheck for DTCs.

Body Electrical > Main Body > Trouble Codes

Result

Proceed to

DTCs are not output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test

Click here

(b) Terminals of ECU

Click here

NEXT
  1. ADJUST, REPAIR OR REPLACE

NEXT

END