Engine Hood Courtesy Switch Circuit
DESCRIPTION
The engine hood courtesy switch is built into the hood lock assembly. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.
WIRING DIAGRAM
NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
- for HEV Model:
Click here
.gif)
- for Gasoline Model:
Click here
.gif)
PROCEDURE
READ VALUE USING GTS
(a) Read the Data List according to the display on the GTS.
Body Electrical > Main Body > Data ListTester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
Hood Courtesy Switch Status |
Engine hood courtesy switch |
Close or Open |
Close: Engine hood closed Open: Engine hood open |
- |
OK:
The GTS display changes correctly in response to the engine hood courtesy switch (hood lock assembly) status.
Body Electrical > Main Body > Data ListHood Courtesy Switch Status
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
|
INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
Click here ![]()
| NG | REPLACE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) |
|
CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND BODY GROUND)
(a) Disconnect the I85 main body ECU (multiplex network body ECU) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
A8-2 (+) - I85-27 (HCTY) |
Always |
Below 1 Ω |
A8-2 (+) or I85-27 (HCTY) - Other terminals and body ground |
Always |
10 kΩ or higher |
A8-1 (E) - Body ground |
Always |
Below 1 Ω |
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |