Security Horn Circuit
DESCRIPTION
When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (multiplex network body ECU) transmits a signal to cause the security horn assembly to sound at intervals of 0.4 seconds.
WIRING DIAGRAM
NOTICE:
- Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
for HEV Model:
Click here
.gif)
for Gasoline Model:
Click here
.gif)
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
PERFORM ACTIVE TEST USING GTS
(a) Perform the Active Test according to the display on the GTS.
Body Electrical > Main Body > Active TestTester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
Security Horn |
Security horn Assembly |
OFF/ON |
- |
Security Horn
OK:
The security horn assembly sounds and stops correctly when operated through the GTS.
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
|
INSPECT SECURITY HORN ASSEMBLY
Click here ![]()
| NG | REPLACE SECURITY HORN ASSEMBLY |
|
INSPECT S-HORN RELAY
(a) Remove the S-HORN relay from the No. 1 engine room relay block. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
3 - 5 |
Auxiliary battery voltage not applied between terminals 1 and 2 |
10 kΩ or higher |
3 - 5 |
Auxiliary battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
| NG | REPLACE S-HORN RELAY |
|
INSPECT POWER DISTRIBUTION BOX ASSEMBLY
(a) Remove the main body ECU (multiplex network body ECU).
Click here ![]()
*a |
Component without harness connected (Power Distribution Box Assembly) |
- |
- |
(b) Disconnect the 8E power distribution box assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
8E-4 - MB-24 (SH) |
Always |
Below 1 Ω |
| NG | REPLACE POWER DISTRIBUTION BOX ASSEMBLY |
|
CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - S-HORN RELAY)
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (S-HORN RELAY - SECURITY HORN ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (S-HORN RELAY - POWER DISTRIBUTION BOX ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |

.png)