High Beam Headlight Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) controls the high beam headlights.
WIRING DIAGRAM
NOTICE:
- Before replacing the main body ECU (multiplex network body ECU), refer to refer to Registration.*1
Click here
.gif)
- Check the operation of the low beam headlights. If the low beam headlights do not operate normally, refer to Problem Symptoms Table.
Click here
.gif)
- First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.
for HEV Model: Click here
.gif)
for Gasoline Model: Click here
.gif)
- *1: w/ Smart Key System
PROCEDURE
PERFORM ACTIVE TEST USING GTS
(a) Enter the following menus: Body Electrical / Main Body / Active Test.
(b) Perform the Active Test according to the display on the GTS.
Body Electrical > Main Body > Active TestTester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
High Beam Headlight |
High beam headlights |
OFF or ON |
- |
High Beam Headlight
OK:
High beam headlights illuminate.
| OK | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
INSPECT H-LP HI RELAY
(a) Remove the H-LP HI relay from the No. 1 engine room relay block.
(b) Inspect the H-LP HI relay.
Click here ![]()
| NG | REPLACE H-LP HI RELAY |
|
CHECK HARNESS AND CONNECTOR (H-LP HI RELAY - BATTERY)
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (H-LP HI RELAY - HEADLIGHT ASSEMBLY LH AND HEADLIGHT ASSEMBLY RH AND BODY GROUND)
(a) Disconnect the A131 headlight assembly LH connector.
(b) Disconnect the A134 headlight assembly RH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
Relay terminal 3 - A131-1 (SOL) |
Always |
Below 1 Ω |
Relay terminal 3 - A134-1 (SOL) |
Always |
Below 1 Ω |
A131-5 (E) - Body ground |
Always |
Below 1 Ω |
A134-5 (E) - Body ground |
Always |
Below 1 Ω |
Relay terminal 3 - Body ground |
Always |
10 kΩ or higher |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (H-LP HI RELAY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
(a) Disconnect the I85 main body ECU (Multiplex network body ECU) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
Relay terminal 1 - I85-22 (DIM) |
Always |
Below 1 Ω |
Relay terminal 1- Body ground |
Always |
10 kΩ or higher |
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
