How To Proceed With Troubleshooting
HINT:
*: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
|
CONNECT GTS TO DLC3*
HINT:
If the display indicates a communication malfunction, inspect the DLC3.
When any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.
|
CHECK DTC AND FREEZE FRAME DATA*
(a) Check for DTCs.
Powertrain > Engine > Trouble Codes(b) Check for Freeze Frame Data.
Click here ![]()
HINT:
Record or print DTCs and Freeze Frame Data if necessary.
|
CHECK VEHICLE CONTROL HISTORY (RoB) AND VEHICLE CONTROL HISTORY FREEZE FRAME DATA*
(a) Check for Vehicle Control History (RoB) and Vehicle Control History Freeze Frame Data.
Powertrain > Engine > UtilityVehicle Control History (RoB)
HINT:
Print Vehicle Control History (RoB) and Vehicle Control History Freeze Frame Data if necessary.
|
CLEAR DTC AND FREEZE FRAME DATA*
(a) Clear the DTCs and Freeze Frame Data.
Powertrain > Engine > Clear DTCs
|
CONDUCT VISUAL INSPECTION
|
SELECT CHECK MODE DIAGNOSIS*
(a) Change the ECM from normal mode to check mode.
Powertrain > Engine > UtilityCheck Mode
|
CONFIRM PROBLEM SYMPTOMS
(a) Confirm the problem symptoms.
HINT:
If the engine does not start, first perform the "Check DTC" procedure and "Conduct Basic Inspection" procedure below.
Result | Proceed to |
|---|---|
Malfunction does not occur |
A |
Malfunction occurs |
B |
| B | GO TO STEP 11 |
|
SIMULATE SYMPTOMS
HINT:
Refer to Symptom Simulation.
Click here ![]()
|
CHECK DTC*
(a) Check for DTCs.
Powertrain > Engine > Trouble CodesResult | Proceed to |
|---|---|
DTCs are output |
A |
DTCs are not output |
B |
| B | GO TO STEP 13 |
|
REFER TO DTC CHART
HINT:
Refer to Diagnostic Trouble Code Chart.
|
CONDUCT BASIC INSPECTION
(a) Conduct basic inspection.
Click here ![]()
Result | Proceed to |
|---|---|
Malfunctioning parts not confirmed |
A |
Malfunctioning parts confirmed |
B |
| B | GO TO STEP 18 |
|
REFER TO PROBLEM SYMPTOMS TABLE
HINT:
Refer to Problem Symptoms Table.
Click here ![]()
Result | Proceed to |
|---|---|
Malfunctioning circuit confirmed |
A |
Malfunctioning parts confirmed |
B |
| B | GO TO STEP 18 |
|
CHECK ECM POWER SOURCE CIRCUIT
(a) Check the ECM power source circuit.
Click here ![]()
|
CONDUCT CIRCUIT INSPECTION
Result | Proceed to |
|---|---|
Malfunction not confirmed |
A |
Malfunction confirmed |
B |
| B | GO TO STEP 19 |
|
CHECK FOR INTERMITTENT PROBLEMS
(a) Check for intermittent problems.
Click here ![]()
|
CONDUCT PARTS INSPECTION
|
IDENTIFY PROBLEM
|
ADJUST AND/OR REPAIR
|
CONDUCT CONFIRMATION TEST
| NEXT | END |