How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the power integration system.
- *: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage with the ignition switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.
|
CHECK COMMUNICATION FUNCTION OF CXPI COMMUNICATION SYSTEM*
(a) Using the GTS, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
| DTCs output | GO TO CXPI COMMUNICATION SYSTEM |
|
CHECK VEHICLE CONTROL HISTORY*
(a) Using the GTS, check for Vehicle Control History (RoB).
Body Electrical > Power Distribution Box > UtilityVehicle Control History (RoB)
(b) If the vehicle control history is output, record it.
Result | Proceed to |
|---|---|
Vehicle Control History (RoB) is not output |
A |
Vehicle Control History (RoB) is output |
B |
| B | GO TO VEHICLE CONTROL HISTORY |
|
CHECK FOR DTC*
(a) Check for DTCs and make a note of any codes that are output.
(b) Clear the DTCs.
Body Electrical > Power Distribution Box > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Power Distribution Box > Trouble Codes| DTCs output | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
PROBLEM SYMPTOMS TABLE
(a) Refer to the Problem Symptoms Table.
Click here ![]()
| Fault is listed in problem symptoms table | ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE |
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
(a) Data List / Active Test
Click here ![]()
(b) Terminals of ECU
Click here ![]()
(c) Problem Symptoms Table
Click here ![]()
|
ADJUST, REPAIR OR REPLACE
| NEXT | END |