Hybrid/EV Battery Internal Electronic Failure (P31B549)
DESCRIPTION
The battery ECU assembly monitors its internal operation and will store these DTCs when it detects an internal malfunction.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Note |
|---|---|---|---|---|---|---|
P31B549 |
Hybrid/EV Battery Internal Electronic Failure |
An abnormal signal is detected by the battery ECU assembly (excessive discharging current). (1 trip detection logic) |
Hybrid vehicle control ECU |
Does not come on |
Master Warning: Comes on |
SAE Code: P31B5 |
CONFIRMATION DRIVING PATTERN
HINT:
After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click here ![]()
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON and turn the GTS on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the ignition switch off and wait for 2 minutes or more.
- Turn the ignition switch to ON and turn the GTS on.
- Drive the vehicle on urban roads for approximately 10 minutes.
- Enter the following menus: Powertrain / HV battery / Utility / All Readiness.
- Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE, perform driving pattern again.
PROCEDURE
CHECK DTC OUTPUT (HV BATTERY, HYBRID CONTROL)
(a) Check for DTCs.
Powertrain > HV Battery > Trouble Codes Powertrain > Hybrid Control > Trouble CodesResult | Proceed to |
|---|---|
"P31B549" only is output. |
A |
DTCs except "P31B549" of hybrid battery system are output. |
B |
DTCs except "P31B549" of hybrid control system are output. |
C |
(b) Turn the ignition switch off.
| A | REPLACE HYBRID VEHICLE CONTROL ECU |
| B | GO TO DTC CHART (HYBRID BATTERY SYSTEM) |
| C | GO TO DTC CHART (HYBRID CONTROL SYSTEM) |